Incorporating non-sterile ingredients into a compounded preparation prior to terminal sterilization is classified as high-risk sterile compounding [13]. USP 〈797〉 states that high-risk CSPs should be used within 24 h of preparation if stored at room temperature, or 3 days if refrigerated, unless sterility testing selleck chemicals llc is conducted to support extended dating. USP chapter 〈71〉 Sterility Tests emphasizes that sterility tests are not by themselves designed to ensure that a batch of product is sterile; rather, this is primarily accomplished by validation
of the sterilization process [14]. By law, USP 〈797〉 is enforceable by the FDA, but in practice the agency generally defers regulation of pharmacies to states [8]. The NABP has incorporated USP 〈797〉 into its Model State Pharmacy Act and Model Rules. Although some states have adopted USP 〈797〉 in its entirety, most State Boards of Pharmacy have only incorporated selected portions of USP 〈797〉 into their regulations or board policies [15]. Any requirements that are not adopted
are not legally enforceable by the state. For example, in 2010 the Texas State Board of Pharmacy rejected a proposal to require the use of sterile gloves and alcohol by pharmacy personnel compounding sterile preparations, despite this being a specific requirement of USP 〈797〉 [16]. A 2011 outbreak of Serratia marcescens bacteremia, which infected 19 learn more patients at six Alabama hospitals, 9 of whom died, was caused by contaminated total parenteral nutrition ID-8 bags from a compounding pharmacy [17, 18]. As a result of this Selleckchem OICR-9429 incident, the Institute of Safe Medication Practices (ISMP) recommended that State Boards
of Pharmacy require compounding pharmacies within their state to comply with all aspects of USP 〈797〉, and inspect these pharmacies regularly to enforce compliance [19]. ISMP stated, “partial compliance will not even partially protect patients from the risk of infection from contaminated CSPs.” ISMP concluded, “Unfortunately, there are too many in healthcare who feel that if it hasn’t happened to them, the adverse experiences of others do not apply.” USP 〈797〉 is an appropriate and practical guidance to implement in a pharmacy that invests in the required equipment and training. However, USP 〈797〉 does not afford the same degree of sterility assurance for compounded drugs that GMPs provide for FDA-approved sterile products [20]. USP 〈797〉 does not provide the necessary protection when compounding expands to mass production of drugs, which requires GMP controls. 3.4 Comparison of Compounded Drugs with FDA-Approved Drugs There are significant differences between compounded drugs and FDA-approved drugs. One important difference is that pharmacy compounded products are not clinically tested for safety and efficacy, nor is bioequivalence testing conducted as is required for generic drugs. The type and extent of quality control testing required for FDA-approved drugs is greater than the testing done on compounded preparations.